In-Person Training
During the recent four years, I have shared a lot of educational content related to designing with ZYNQ with many developers across the world.
This also contains educational packages on development of required Linux software and Linux kernel level drivers for the hardware blocks that we create on the ZYNQ PL. The educational packages I have created on this topic however, are not free and are available at a cost.
In addition, there exist possibility of in-person training workshops here in Munich. You can travel to Munich, and have a one or two days workshop on development of Linux kernel level drivers for your custom hardware for ZYNQ and ZYNQ Ultrascale+ platforms.
Workshops are also available for any other favorite topic related to FPGA design or ZYNQ platform and embedded system design using MPSoC.
The workshop will be held in well equipped meeting room at the center of Munich. The contents of the workshop will be tailored according to your needs.
Please contact me if interested. Contact info can be found on the first page of this web site.
Dear Mohammad,
first thank you very much for your amazing videos on qt & zynq ultrascale.
We are located in sargans switzerland only arround 2 hours from munich 🙂
We are currently doing a project with a EZA3 board from myirtech http://www.myirtech.com/list.asp?id=630 for a printhead driver electronics.
FPGA design runs fine in simulation we already have built the pentalinux and can already download our logic to the FPGA.
Now we are working to get the qt running but have some error messages with the SDK.
I am highly interested in your educational material and i wanted to ask if we could hire your hourwise support us a little on getting the qt running
and possibly also for some future training.
Kindest Regards
Erik Huber